Operating Instructions
(Continued on next page)
23
TIMBERWOLF FIREWOOD PROCESSING EQUIPMENT
• Raise hitch latch to unlocked position
• Make sure you are using a 2” ball
• Attach log splitter’s 2” ball coupler fi rmly to 2” ball on tow vehicle hitch
• Lower hitch latch into locked position and secure with locking pin
• Cross the safety chains under the hitch and fasten them securely to the tow vehicle. Leave enough slack in the chains to permit
turning
• Use crank to raise leveling jack/wheel assembly as far up as it will go
WARNING!
Towing the log splitter can cause unstable driving conditions and increase the risk of an accident
• Do not exceed 30 mph while towing the log splitter
• Log splitter will turn more sharply than the tow vehicle
• Do not back up with log splitter connected to the tow vehicle ; splitter can jackknife
Transporting the Log Splitter (continued)
To Next Page
Loading...
