Timpte Tender - Programming Remote to Work with the Ez Flow Trap System

21
Date of Origin – 02/24/11
Updated – 02/03/20
To control work lights (optional)
• On the trailer keypad press and release the top “AUX” button to turn on or off the worklights.
• On the remote press the “WORKLIGHT ON/OFF” button to turn on or off the worklights.
PROGRAMMING REMOTE TO WORK WITH
THE EZ FLOW TRAP SYSTEM
1. Power on the keypad controller on the trailer by holding the
“FRONT OPEN” and “FRONT CLOSE” buttons on the keypad
simultaneously for 3-5 seconds or until the blue light illuminates to
indicate the system is activated.
2. Open the ip lid on the remote and observe the illuminated buttons to
indicate the remote is active.
3. Repeat step 2 for each remote to be programmed. Up to four remotes
can be programmed. Have all remotes ready for steps 4 & 5. Ignore
if only one remote is to be programmed.
4. Press and hold the two “AUX” buttons on the keypad controller simultaneously
for 10 seconds until the blue ashing light stays solid then release. The light
on the keypad controller should start ashing violet.
5. Press and hold the “FRONT OPEN” button on the remote for 2 seconds or
until the blue ashing light on the
keypad turns white then release the button. The keypad light on the trailer
should then continue blinking violet.
6. Repeat step 5 for up to four remotes to be programmed. Ignore if only one
remote is being programmed.
7. Once all remotes are programmed press the top “AUX” button to exit programming
or let the system timeout after 10 seconds. The keypad controller light should ash
two sets of red indicating the remotes have been saved.
Operating Remote with the EZ Flow Trap System
Powering up or down the system
• Open the remote ip lid and observe the buttons illuminate indicating the remote
is active.
• Press and hold the “FRONT OPEN” and “FRONT CLOSE” buttons on the remote
simultaneously for 3-5 seconds or until the blue light on the keypad controller
illuminates to indicate the system is activated.
• Repeat the above steps to turn off the EZ Flow Trap System.
To use the front hopper doors
• Press and hold the desired directional button to open or close the front doors.
The hopper door will travel in that directuion until the button is released.
To use the rear hopper doors
• Press and hold the desired directional button to open or close the rear doors.
The hopper door will travel in that direction until the button is released.
CAUTION! - When any button on the remote is pressed, the status LED will ash rapidly indicat-
ing it is transmitting a signal. The status LED on the remote will ash continuously when the remote
batteries have 25% charge left. Always close the remote lid when not in use to prevent accidental
button presses that can cause unwanted operation of the tarp or trap systems. When ip lid is in the
closed position the remote is deactivated.