TINNO CELERO 5G - Regulatory Agency Identifications; FCC Regulations; RF Exposure Information (SAR)

35
Regulatory agency identications
FCC Regulations
This mobile phone complies with Pa 15 of the FCC Rules.
Operation is subject to the following two conditions:  This device may not cause
harmful inteerence, and  this device must accept any inteerence received,
including inteerence that may cause undesired operation.
This mobile phone has been tested and found to comply with the limits for a Class
B digital device, pursuant to Pa 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful inteerence in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful inteerence to radio communications.
However, there is no guarantee that inteerence will not occur in a paicular
installation. If this equipment does cause harmful inteerence to radio or television
reception, which can be determined by turning the equipment o and on, the user
is encouraged to try to correct the inteerence by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modications not expressly approved by the pay responsible for
compliance could void the user's authority to operate the equipment.
Operation of transmiers in the 5.925-7.125 GHz band is limited to indoor use only.
Operation prohibited on oil plaorms, cars, trains, boats, and aircra, except that
operation of this device is permied in large aircra while ying above 10,000 feet.
Operation of transmiers in the 5.925-7.125 GHz band is prohibited for control of or
communications with unmanned aircra systems.
RF Exposure Information (SAR)
This mobile phone meets the government's requirements for exposure to radio
waves. This phone is designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government. The exposure standard for wireless mobile
phones employs a unit of measurement known as the Specic Absorption Rate, or
SAR. The SAR limit set by the FCC is 1.6 W/kg. Tests for SAR are conducted using
standard operating positions accepted by the FCC with the phone transmiing at
its highest ceied power level in all tested frequency bands.