Warnings, Safety Information and Guidance
Important Information
Important: read these instructions fully before the installation of this appliance
1. This manual covers the operation of the HRV control system only, it must therefore be read
in conjunction with the relevant heat recovery unit Product Manual.
2. Installation of the appliance and accessories must be carried out by a qualied and suitable
competent person and be carried out in clean, dry conditions where dust and humidity are
at minimal levels.
3. All wiring must conform to current I.E.E. Wiring Regulations and all applicable standards
and Building Regulations.
4. aurastat®, control & communication cable access to the HRV is via the tted cable gland(s)
which are suitable for Ø3- 6mm cable.
5. aurastat® control & communication cable - Unshielded 4 Core 18-24AWG Stranded, Tinned
Copper.
6. Control & communication cables should not be placed within 50mm or on the same metal
cable tray as any 230V lighting or power cables.
7. Ensure all cable glands are fully tightened.
8. The unit must be stored in a clean and dry environment. Do not install the appliance in
areas where the following may be present or occur;
• Excessive oil or a grease laden atmosphere,
• Corrosive or ammable gases, liquids or vapours,
• Ambient temperatures above 40°C or below -5°C,
• Humidity levels above 90% or is a wet environment.
9. The appliance is not suitable for installation to the exterior of the dwelling.
10. This appliance can be used by children aged from 8 years and above and persons with re-
duced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way
and understand the hazards involved.
11. Children should be supervised to ensure that they do not play with the appliance.
2
To Next Page
Loading...