8
5. HANDLING PRECAUTIONS
• Please apply the latest rmware version to this product. The latest version is available at the TOA
DATA Library (https://www.toa-products.com/international/).
• As this product is IP-based, a slight time lag between actual and broadcast may happen.
• Broadcast audio may sometimes break up due to packet loss or network failure.
• Periodic inspection and manual rebooting are needed to extend the product life.
•
This product may reboot automatically to keep the stable operation.
6. INSTALLATION PRECAUTIONS
Observe the following instructions when attaching the safety wire. Failure to do so could result in
the speaker falling, potentially resulting in personal injury.
• Select a safety wire that is strong enough to withstand the total weight of the speaker being
mounted.
• Use a wire with a diameter larger than 1.5 mm or 0.06".
• Attach the safety wire so that it does not become slack.
CAUTION
Notes
• Since safety wire is not supplied with the IP horn
speaker, be sure to prepare it separately.
• When attaching the safety wire, be sure that it is
fastened securely to the safety wire attachment
ring.
Mount the speaker so that its downward inclination is within 80° of horizontal, and the cable inlet is
facing downward, as shown in the gure below.
5 (0.2")
16
(0.63")
Unit: mm
Safety wire attachment ring
Cable
Downward
inclination: 80°
141 (5.55")
25 (0.98")
50 (1.97")
3 – ø9
(0.12" – ø0.35")
36
(1.42")
[Mounting bracket dimensional drawing]
Unit: mm
To Next Page
Loading...
