EasyManuals Logo

TOHATSU EverRun MX 18E2 User Manual

TOHATSU EverRun MX 18E2
158 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
ENGINE OPERATION20
5
In case engine starts in gear, do not start
cruising. Stop engine immediately and con-
sult an authorized dealer.
Note
The engine will not start unless the switch
lock has been properly connected into the
emergency stop switch.
Do not operate the engine with gear case
out of water.
Severe personal injury, or engine damage
will result.
Never fill up portable fuel tanks on board to
avoid fire or explosion resulting from
spilled gasoline. If gasoline is ever spilled
on board, wipe it up thoroughly. Fuel tanks
must always be filled up on land.
Preparations
1
Loosen the air vent screw on the tank
cap.
2
Connect the fuel connector to the
engine.
3
Install a lock in the stop switch.
4
Feed fuel to the carburetor by squeez-
ing the primer bulb until firm.
5
Place the shift lever in the Neutral posi-
tion.
Be sure that the shift is in Neutral when
starting the engine.
This model is provided with start in gear
protection.
1. Starting
WARNING
WARNING
CAUTION
Fuel tank side
Engine side
ENGINE OPERATION
MX18E2_E.book Page 20 Tuesday, August 2, 2011 12:37 PM

Table of Contents

Other manuals for TOHATSU EverRun MX 18E2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TOHATSU EverRun MX 18E2 and is the answer not in the manual?

TOHATSU EverRun MX 18E2 Specifications

General IconGeneral
BrandTOHATSU
ModelEverRun MX 18E2
CategoryOutboard Motor
LanguageEnglish

Related product manuals