ENGINE OPERATION 35
7
5. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
repeat if necessary until started.
1. Slowly
2. Quickly
3. Starter handle
(For electrical starter type)
4. Push the starter switch button and
release the button when the engine
has started.
1. Starter Button
5. Check the cooling water from cooling
water check port.
Side mount RC type
1. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
1. Stop switch lock
2. Insert the main switch key.
3. Set the control lever in the Neutral
position.
4. Raise the free accel lever a little (both
of cold engine and warm engine).
ENON00504-0
Note
The free accel lever can not be raised when
the control lever shift is in Forward or
Reverse.
To Next Page
Loading...
Need help?
General
