INSPECTION AND MAINTENANCE62
10
ENOM00090-B
It is important to inspect and maintain your outboard motor regularly. At each interval on
the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or number
of months, whichever comes first.
2. Periodic Inspection
Description
Inspection intervals
Inspection procedure Remarks
First 20
hours or 1
month
Every 50
hours or 3
months
Every 100
hours or 6
months
Every 200
hours or 1
year
Fuel System
Carburetorr*1
Check and clean, if necessary.
Fuel filter
Check and clean or Replace if
necessary. (See page 66)
Piping/Hoses
Check and clean or Replace if
necessary.
Fuel tank
Clean (See page 69)
Fuel tank cap
Check and clean or Replace if
necessary.
Fuel pump
*1
Check and clean or Replace if
necessary.
Ignition Spark plug
Check gaps. Remove carbon deposits
or Replace if necessary. (See page 69)
0.8-0.9 mm
(0.031-0.035 in)
Starting
System
Starter rope
Check for wear or chafing
Starter motor
*1
Check for salt deposits and the battery
cable condition.
Battery
Check installation, fluid quantity, gravity.
Engine
Engine oil
Replace
Replace
Replace. (See page 58)
1800 ml
(1.9 US qt.)
Oil filter
*1
Replace every 200 hrs or 2 years (See
page 65)
Entire cartridge
Valve Clearance
*1
Check & adjust
IN:
0.13-0.17 mm
(0.0051-0.0067 in)
EX:
0.18-0.22 mm
(0.0071-0.0087 in)
Timing belt
*1
Check and Replace if necessary.
Compression
pressure*1
Check and repair if necessary.
Combusion
chamber*1
Clean every 200 hrs or 2 years
Thermostat
*1
Check and Replace if necessary.
MFS15-20D_EUR_EN_141119N.book 62 ページ ２０１４年１２月２３日 火曜日 午後６時４１分
To Next Page
Loading...
Need help?
General
