TOHATSU mfs 15D User Manual

INSPECTION AND MAINTENANCE 63
10
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the best
time for major maintenance procedures to be carried out.
ENOM00091-A
Engine oil replacement
Engine oil mixed with dust or water will
dramatically shorten the life of the engine.
ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after
stopping. Changing engine oil should be
done after the engine has been cooled.
ENOW00092-0
 Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper
limit marks of oil gauge, drain oil to level
lower than upper limit.
 Be sure that outboard motor is in upright
and level position when checking or
changing oil.
 Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is
found, or engine could be severely dam-
aged. Consult dealer.
 Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
ENOW00090-0
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
Lower Unit
Propeller

Check for bent blades, damage, wear.
Replace if necessary. (Seepage 68)
Gear oil
Replace


Replace

Change or replenish-oil and check for
water leaks. (See page 74)
500 mL (16.9
fl.oz.)
Cooling water
inlet

Check clogging
Water pump
*1

Replace

Check for wear or damage and replace
if necessary
Replace impeller
every 12 months.
Power tilt
*1

Check & replenish oil, manually operate
Warning system
*1

Check function
Bolts and Nuts

Retighten
Throttle wire

Check for wear or damage and replace
if necessary
Remote control cable

Check and adjust if necessary
Sliding and Rotating Parts.
Grease Nipples

Apply and pump in grease. (See
page 73)
Outer Equipment

Check for corrosion.
Anode

Check for corrosion and deformation.
Replace if
necessary.
Description
Inspection intervals
Inspection procedure Remarks
First 20
hours or 1
month
Every 50
hours or 3
months
Every 100
hours or 6
months
Every 200
hours or 1
year
CAUTION
CAUTION
CAUTION
MFS15-20D_EUR_EN_141119N.book 63 ページ ２０１４年１２月２３日 火曜日 午後６時４１分

TOHATSU mfs 15D Specifications

General

Brand	TOHATSU
Model	mfs 15D
Category	Outboard Motor
Language	English