INSPECTION AND MAINTENANCE 65
10
ENON00920-0
Note
Use only recommended engine oil (See
page 13)
ENOW00925-0
Wipe off engine oil well immediately if
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
ENON00031-0
Note
If any amount of water is found in engine
oil, making it milky white, consult dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult dealer.
Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
ENOM00092-A
Oil filter replacement
ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after
stopping. Changing engine oil should be
done after the engine has been cooled.
ENOW00926-0
Wipe off engine oil well immediately if
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
1. Drain oil from the engine.
2. Place a rag or towel below the oil filter
to absorb any spilled oil.
3. Unscrew old filter by turning the filter to
counter clockwise.
4. Clean the mounting base. Apply film of
clean oil to O-ring.
Do not use grease.
Install oil filter and tighten it to specified
torque by using oil filter wrench.
Oil filter torque:
18 Nm (13 ft
-lb, 1.8 kgf-m)
ENON00028-A
Note
If a torque-wrench is not available when you
are fitting a oil filter, a good estimate of the
correct torque is 3/4 to 1 a turn past finger-
tight. Have the oil filter adjusted to the cor-
rect torque as soon as possible with a
torque-wrench.
Oil volume needed for complete oil replace-
ment
With oil filter replace-
ment
Without oil filter
replacement
1200 mL
(1.27 US qt.)
1000 mL
(1.06 US qt.)
CAUTION
10W−40
10W−30
˚C
˚F
40
96
30
86
20
68
10
50
0
32
-10
14
-20
-4
-30
-22
ENOF00208-0
CAUTION
CAUTION
MFS15-20D_EUR_EN_141119N.book 65 ページ ２０１４年１２月２３日 火曜日 午後６時４１分
To Next Page
Loading...
Need help?
General
