31
7
ENGINE OPERATION
ENOM00042-0
ENOW00022-A
The engine oil is drained for shipping from
the factory. Be sure to fill the engine to the
proper level before starting engine. (To
properly fill the engine with oil follow the
instructions. See page 50)
ENOW00027-B
Before starting engine for the first time after
reassembling engine or off-season storage,
disconnect stop switch lock and crank
approximately 10 times in order to prime the
oil pump.
ENOM00044-D
ENOW00029-A
When opening fuel tank cap, be sure to fol-
low the procedure described below. Fuel
could blast out through the fuel tank cap in
case the cap is loosened by using another
procedure when internal pressure of fuel
tank is raised by heat from sources such as
sun light.
ENOW00030-B
When using EPA approval fuel tank, only use
a primer bulb/hose assembly that has a Fuel
Demand Valve (FDV) installed in the fuel hose
or a sealing mechanism in the fuel connector
as shown below.
FDV and fuel connector that has an sealing
mechanism prevent pressurized fuel spillage
when the fuel connector is connected to the
engine.
1. FDV in fuel hose
2. Sealing mechanism in fuel connector
3. Identification
Do NOT use a primer bulb/hose assembly
that does not contain a Fuel Demand Valve or
a sealing mechanism as shown below: other-
wise fuel spillage may occur when the con-
nector is connected to the engine.
Do not connect fuel connector except when
operating engine. Fuel leakage is a fire or
explosion hazard, which can cause serious
injury or death.
Before starting
CAUTION
CAUTION
1. Fuel feeding
WARNING
WARNING
To Next Page
Loading...
Need help?
General
