ENGINE OPERATION 39
7
Emergency engine stopping
Remove stop switch lock to stop the
engine.
1. Hock
2. Stop switch lock
3. Stop switch
ENOM00910-0
Spare emergency stop switch lock
A spare emergency stop switch lock is
provided in the tool bag.
When used as described, the emergency
stop switch clip and emergency stop
switch lanyard system stops the engine if
the operator falls away from the controls.
When an operator falls into water, be
sure to use emergency stop switch lock
of the spare.
Be sure to confirm the spare stop switch
lock is in the tool bag before begin to
operate.
ENOM00920-A
ENOW00870-0
Sudden steering may cause passenger(s) to
be thrown overboard or falling down.
Tiller handle type
Right turn
Move the tiller handle to the left
Left turn
Move the tiller handle to the right.
ENOM00050-0
ENOW00043-A
z Adjust the trim angle when the engine is
stopped.
z Do not put hand or finger in between out-
board motor body and clamp bracket
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
z Unsuitable trim position can cause loss of
control of boat. When testing a trim posi-
tion, run boat slow initially to see if it can
be controlled safely.
2
3
1
ENOF00210-0ENOF00439-0
ENOF00891-0
6. Steering
WARNING
7. Trim angle
WARNING
ENOF00892-0
To Next Page
Loading...
Need help?
General
