EasyManuals Logo

TOHATSU MFS 4C User Manual

TOHATSU MFS 4C
78 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
INSPECTION AND MAINTENANCE 65
10
ENOW00066-0
Do not carry or store outboard motor in any
of positions described below.
Otherwise, engine damage or property dam-
age could result from leaking oil.
ENON00021-1
Note
z If the outboard motor must be laid
down be sure drain the fuel, then the
outboard motor on a cushion as shown
in the following drawing (See page 65
and 45).
z Elevate power unit 2 inches to 4 inches
if traveling to avoid oil spillage.
ENOM00950-0
Adding a fuel stabilizer
When adding a fuel stabilizer additive
(commercially available), first fill the fuel
tank with fresh fuel. If the fuel tank is only
partially filled, air in the tank can cause
the fuel to deteriorate during storage.
1. Before adding fuel stabilizer additive,
drain the carburetor (See page 66).
2. Follow the instructions on the label
when adding the fuel stabilizer addi-
tive.
3. After adding the additive, let the out-
board motor run in the water for 10
minutes to make sure any old fuel in
the fuel system has been completely
replaced by the fuel with additive.
4. Turn the engine OFF
ENON00891-0
Note
If your motor is used occasionally, it is rec-
ommended to use a good fuel stabilizer in
every tank of fuel and keep the container
full to reduce condensation and evapora-
tion.
CAUTION
ENOF01511-0
ENOF01510-0
ENOF01512-0

Other manuals for TOHATSU MFS 4C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TOHATSU MFS 4C and is the answer not in the manual?

TOHATSU MFS 4C Specifications

General IconGeneral
BrandTOHATSU
ModelMFS 4C
CategoryOutboard Motor
LanguageEnglish

Related product manuals