ENGINE OPERATION36
7
9. After engine starts, do not reinstall
flywheel cover and top cowl.
ENOM00043-A
ENOW00932-0
Be sure to check that cooling water is com-
ing out of the cooling water check port dur-
ing warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 41°F (5 Υ )
5 minutes at 2000 min
-1
(rpm) : below
41°F (5 Υ )
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
1. Cooling water check port
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 min
-1
(rpm) for several minutes.
ENOM00046-A
ENOW00037-0
Before shifting into forward or reverse, make
sure that boat is properly moored and out-
board motor can be steered fully to the right
and left. Make sure that no swimmer(s) is
ahead or astern of the boat.
ENOW00038-A
z Attach other end of emergency stop
switch lanyard to the operator's PFD (Per-
sonal Flotation device) or arm and keep it
attached during cruising.
z Do not attach the tether to a part of
clothing that can be torn easily when
pulled.
z Arrange the tether so that will not be
caught by any object when pulled.
z Be careful not to pull the tether acciden-
tally during cruising. Unintentional stop of
engine can cause loss of control of out-
board motor. Rapid loss of engine power
can lead to falling down or causing pas-
senger(s) to be thrown overboard.
ENOW00042-0
z Do not shift into Reverse during planing,
or control will be lost leading to serious
personal injury, boat may swamp, and/or
hull may be damaged.
z Do not shift into Reverse during cruising,
or control may be lost, falling down or
causing passenger(s) to be thrown over-
board. Leading to serious personal injury,
and steering system and/or shifting
mechanism may be damaged.
3. Warming up the engine
CAUTION
Clutch in (In gear) Clutch off (Out of gear)
1100 min
-1
(rpm) 1300 min
-1
(rpm)
4. Forward, reverse, and
acceleration
WARNING
WARNING
WARNING