ENGINE OPERATION 33
7
ENOM00045-C
ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump dam-
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 59)
Run the engine only at idling.
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-0
Be sure to stop engine immediately if cooling
water check port is not discharging water,
and check if cooling water intake is blocked.
Operating engine could lead to overheating
potentially leading to engine damage. Con-
sult an authorized dealer if the cause cannot
be found.
ENOW00032-B
Do not try to crank after engine has started.
This model is provided with start in gear
protection.
ENON00010-0
Note
Start-in-gear protection prevents engine
from starting at other than neutral shift.
In-gear starting of engine will move the
boat immediately, potentially leading to
falling down or causing passenger(s) to be
thrown overboard.
Tiller handle type
1. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
1. Stop switch lock
2. Set the shift lever in the Neutral posi-
tion.
1. Shift lever
2. Starting the engine
CAUTION
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
