INSPECTION AND MAINTENANCE56
10
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn past
finger-tight. Have the oil filter adjusted to
the correct torque as soon as possible with
a torque-wrench.
6. Reset the engine in a vertical posi-
tion.
7. Repeat 3 to 7 procedures two or
three times to drain the oil com-
pletely.
8. Remove the top cowl and the oil filler
cap.
9. Fill the engine through filler port with
recommended oil (see chart below)
to the middle of dipstick mark.
10. Tighten the oil filler cap.
1. Oil filler cap (Dipstick)
1. Upper limit (Max.)
2. Lower limit (Min.)
ENON00920-0
Note
Use only recommended engine oil (See
page 12)
ENOW00925-0
Wipe off engine oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
ENON00031-0
Note
z If any amount of water is found in
engine oil, making it milky white, consult
dealer.
z If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
z Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
ENOM00093-A
Fuel filters and fuel tank cleaning
ENOW00093-A
Gasoline and its vapors are very flammable
and can be explosive.
Oil volume needed for complete oil replacement
450 mL (0.48 US qt.)
CAUTION
WARNING
10W−40
10W−30
˚C
˚F
40
96
30
86
20
68
10
50
0
32
-10
14
-20
-4
-30
-22
ENOF00208-0
To Next Page
Loading...
Need help?
General
