INSPECTION AND MAINTENANCE58
10
ENOM00098-A
Gear oil replacement
ENOW00094-0
z Be sure that outboard motor is secured to
transom or service stand, or accidental
drop or fall of outboard motor could lead
to severe personal injury.
z Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
z Do not go under outboard motor tilted up
and locked, or accidental fall of outboard
motor could lead to severe personal
injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
3. Insert the oil tube nozzle into the
lower oil plug hole, and fill with gear
oil by squeezing the oil tube until oil
flows out of the upper plug hole and
bubbles is disappeared to remove the
air.
ENON00033-0
Note
Use genuine gear oil or the recommended
one (API GL-5: SAE #80 to #90).
Required volume: approx. 195 mL (6.6
fl.Oz).
4. Install the upper oil plug, and then
remove oil tube nozzle and install the
lower oil plug.
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
WARNING
CAUTION
To Next Page
Loading...
Need help?
General
