22
Using voice command and control
Note: You must select a computer voice in order to use voice command and
control. To select a computer voice, tap Voices in the Preferences menu, then
tap Change voice. Select a computer voice.
In this example, you will use voice command and control to plan a journey to
your Home address.
1. Tap the microphone button in the Driving View.
Note: To add or remove this button from the Driving View, tap Com-
mand and control in the Preferences menu, then tap Enable com-
mand and control or Disable command and control.
The microphone monitor is shown in colour, unless command and control
is busy with another task.
2. When you hear a beep, say, "Navigate to Home."
When you speak, the microphone monitor shows if you are talking too
loudly or quietly:
A green bar means your voice is at the right level for your device
to hear your commands.
A red bar means your voice is too loud.
A grey bar means your voice is too quiet.
For some phrases, your device repeats the command, then asks you if the
command has been correctly recognised.
3. If the command is correct, say, "Yes."
If the command is incorrect, say, "No" and when prompted, say the com-
mand again after the beep .
Your device plans a route from your current position to your Home address.
Tips
• The microphone switches off after a few seconds if you don’t say anything.
• You can stop your device from listening for commands either by tapping
the screen or by saying any of the following commands: Back, Cancel, Quit.
• To select an item from a list, tap the screen to select the item. Voice control
cannot be used to select items from a list.
To Next Page
Loading...
