46
Start-up preferences
Set clock
Set units
Start-up
preferences
Tap this button to select what happens when your device starts. The follow-
ing options are available:
• Continue where I left off - your device starts and shows the last screen
that was shown when you turned off the device.
• Ask for a destination - your device starts with Navigate to... menu or the
list of frequent destinations, if you have set some frequent destinations.
• Show the Main Menu - your device starts with the Main Menu.
• Start Slideshow - your device starts by showing a slideshow of the
images stored there. To interrupt the slideshow, tap the screen.
You are then asked if you want to change the picture that is shown when-
ever you start your device.
Tap No to finish or tap Yes to see the photos stored on your device and tap
on a photo to select that photo for use as your start-up picture.
Set clock
Tap this button to select the time format and to set the time.
The easiest way to set the time is by tapping the Sync button. Your
Blue&Me-TomTom will then take the time from GPS information.
Note: You can only use Sync if you have GPS reception, so you cannot set
the clock in this way when you are indoors.
After using Sync to set the time, you may have to adjust the hours depend-
ing on your time zone. Your Blue&Me-TomTom works out your time zone
and always keeps the time correct using GPS information.
Set units
Tap this button to set the type of units that will be shown for the following:
•Distance
•Time
• Latitude and longitude
To Next Page
Loading...
