TomTom RIDER 2nd Edition User Manual

19
•
•
•
•
•
•
Tap YES to enter an arrival time. RIDER shows you whether you will arrive
on time.For more information, see Arrival times on page 19.
The route is then calculated by your TomTom RIDER.
9. When the route has been calculated, tap Done.
TomTom RIDER will immediately start guiding you to your destination with
spoken instructions and visual instructions on the screen.
You should plan your route before you start driving. It is not possible to plan
the route in this much detail once you start moving. While you are driving,
only the driving menu is displayed. For more information, see this chapter:
Menus on page 25.
Arrival times
When you plan a route, your RIDER asks you if you need to arrive by a
particular time:
Tap YES to enter an arrival time.
Your RIDER calculates your arrrival time and shows you whether you will
arrive on time. Your arrival time is constantly recalculated during your trip.
The status bar shows whether you will arrive on time or late, as shown below:
Note: Before you can plan a route in this way, TomTom RIDER must first
locate your current position.
You will arrive 55 minutes before the arrival time you entered.
If the estimated arrival time is more than five minutes before the
time you entered, it is shown in green.
You will arrive 3 minutes before the arrival time you entered.
If the estimated arrival time is less than 5 minutes before the
time you entered, it is shown in yellow.

TomTom RIDER 2nd Edition Specifications

General

Marine (chartplotters, sounders)	No
Map view options	2D/3D
Form factor	Fixed
Channels quantity	20 channels
Display diagonal	3.5 \
Display resolution	320 x 240 pixels
Internal memory	32 MB
Power requirements	12V
Processor frequency	380 MHz
USB 2.0 ports quantity	1
Battery life (max)	5 h
Operating temperature (T-T)	-10 - 55 °C

Weight and Dimensions

Depth	96.2 mm
Width	113.2 mm
Height	52.9 mm
Weight	310 g