TomTom RIDER 2nd Edition User Manual

33
•
•
•
•
•
•
Chapter 10
Using the Map
Using the Map
Every time you use your TomTom RIDER to plan a route, you are using the
map. However, you can use the map in many other ways.
To open the map, tap Browse map in the Main Menu.
Place your finger on the screen and drag it across the screen to move the map.
A The scale bar
B Your current position
C GPS button.
Tap this button to center the map on your current position.
D The Options button
Use the Options button to set what is shown on the map.
E The cursor
F The Find button
Tap this button to find specific addresses and Points of Interest on the map.
G The Cursor button
Tap this button to navigate to the cursor position, make a Favorite of the
cursor position, or find a Point of Interest near the cursor position. See
below for more information.
H The zoom bar.
Change the scale of the map by moving the zoom bar up or down.
Using the Cursor button
You can use the map to find addresses and Points of Interest (POIs), for
example, restaurants, train stations and petrol stations.
With the Cursor button, you can use what you have found. Tap the Cursor
button to open the page of buttons shown below:

TomTom RIDER 2nd Edition Specifications

General

Marine (chartplotters, sounders)	No
Map view options	2D/3D
Form factor	Fixed
Channels quantity	20 channels
Display diagonal	3.5 \
Display resolution	320 x 240 pixels
Internal memory	32 MB
Power requirements	12V
Processor frequency	380 MHz
USB 2.0 ports quantity	1
Battery life (max)	5 h
Operating temperature (T-T)	-10 - 55 °C

Weight and Dimensions

Depth	96.2 mm
Width	113.2 mm
Height	52.9 mm
Weight	310 g