Topcon HiPer VR - Getting Started

Features
Power
Button
STAT
Bluetooth
REC Cellular
Radio
Battery
Serial
Power
Micro
USB
External
GNSS
Antenna
TNC or
BNC
SIM Card
(Model
dependent)
Reset
Button
Getting Started
Turning the Receiver On and Off
To turn on the receiver, press and hold the power button until the LEDs briey
ash. The receiver is turning on when: the Power LED blinks green, the receiver
channels initialize and start tracking all visible satellites at any time and location,
and the serial port is available. When the startup is complete, the Power LED is
solid green only when external power is used; otherwise the Power LED is off.
After startup, the integrated wireless devices in the receiver are ready to use,
and the receiver is available to obtain the correction data from reference station
and to measure ground point coordinates with high accuracy. Also the receiver
is ready to start data recording to the internal memory.
To turn-off the receiver, press and hold the power button for more than 3 but
less than 10 seconds. Release the power button when the Power LED blinks
yellow. This delay prevents the receiver from being turned off by mistake.
Allow the receiver to complete the power off cycle, which is approximately 15
seconds.
Powering the Receiver
The receiver is powered by an internal battery or an external valid power source
connected to the power port. If an external power source is connected, the
receiver draws power from it instead of the battery. You can connect the receiver
to an external power source, such as a vehicle battery, with 9 – 27 VDC to
operate the receiver.