Topcon HiPer VR Quick Reference Card

RADIO LED - UHF GNSS RECEIVER
Command mode (rover and base)
Red Blink
+ Green Blink
+ No light
MAGNET Field or TRU sends commands to congure the
GNSS receiver.
Receiver mode (rover)
Green Solid Modem is not receiving correction data.
Yellow Blink Modem is receiving correction data from a base.
Transmitter mode (base)
Green Solid Modem is not transmitting correction data.
Red Blink Modem is transmitting correction data.
Retranslator mode (base)
Yellow Blink
+ Red Blink
Modem is receiving and transmitting correction data.
RADIO LED - FH915+ GNSS RECEIVER
Command Mode (rover and base)
Red Blink
+ Green Blink
MAGNET Field or TRU sends commands to congure
the modem.
Receiver mode (rover)
Green Blink Modem is not synchronized with a base.
Green Solid
Modem is synchronized with a base and ready to receive
correction data.
Yellow Solid Modem receives correction data from a base.
Transmitter mode (base)
Red Solid Modem transmits correction data.
BATTERY LED
The receiver is on—and the internal battery is in use
Green Solid The charge is greater than 50%.
Yellow Solid The charge is between 10% and 50%.
Red Solid The charge is less than 10%.

Topcon HiPer VR Specifications

General

Battery Life	Up to 10 hours
Ingress Protection	IP67
Internal Memory	8 GB
Signal Tracking	GPS, GLONASS, Galileo, BeiDou, QZSS, SBAS
Static Accuracy Horizontal	3 mm + 0.1 ppm
Static Accuracy Vertical	5 mm + 0.5 ppm
Communication	Bluetooth, Wi-Fi
Operating Temperature	-40°C to +65°C
Update Rate	20 Hz