Topshine MT01 - Page 25

Guangzhou Topshine Information Technic Co., LTD
Address: RM 605, #52 SHUI YIN RD, YUE XIU DIST, GUANGZHOU, CHINA
User manual of tracker MT01
-
25
-
Set Time Interval for
Sending GPRS Packet
W******,014,XXXXX
XXXXX should be in five
digitals and in
unit of 10 seconds.
XXXXX=00000,to disable this
function;
XXXXX=00001~65535, time
interval for sending GPRS
packet and in unit of 10
seconds.
Output Control
W******,020,P,F
P =1, Out1
=2, Out2
=3, Out3
=4, Out4
=5, Out5
F =0, to disable the output
=1, to enable the output
Output Control (Safe
mode)
This function is achievable
when the speed is below
10km/h and GPS is
available.
W******,120,ABCDE
ABCDE represents Out1,
Out2, Out3,
Out4, Out5 respectively.
If A or B or C or D or E,
=0, to disable the output
=1, to enable the output
=2, to remain previous status
Set power saving mode
when MT01 is still
(In power saving mode, GPS
stops working. GSM enters
standby mode and stop
sending out message until it is
activated by an SMS or an
incoming call)
W******,026,XX
XX=00, to disable this
function
XX=01~99, to set this
function. It is in
unit of minute.
Example:
If XX=10, MT01 will enter
power
saving mode in 10 minutes
after it is
immobile.
Set phone number for
wiretapping
W******,030,T
T is the telephone number for
wiretapping and max. 16 digits
Set time zone difference
W******,032,T
T=0, to disable this function
T=[1, 65535] to set time
difference in
minutes to GMT.
Default value is GMT
+, not necessary for those
ahead of
GMT. For example, either