How to fix Topshine GPS unit that will not turn on?
If your Topshine GPS unit will not turn on, it could be due to the following reasons: * The wiring may not be connected properly; check and ensure the wiring connection is correct. * The battery may need charging; recharge the battery.
What to do if SMS from Topshine GPS MT100 states “last......”?
If your Topshine GPS MT100 sends an SMS stating 'last......', it indicates that the unit doesn't have a clear view of the sky. To resolve this, move the antenna of the unit to a location where the sky is visible. Alternatively, the MT100 might be in an inner place; wait for the target to come out.
General| Chipset | SiRF Star III |
|---|---|
| Frequency | L1, 1575.42 MHz |
| C/A code | 1.023 MHz chip rate |
| Sensitivity | -159 dBm |
| Acquisition | Cold start: 35 sec, Warm start: 33 sec, Hot start: 1 sec |
| TTFF (Open Sky) | Cold start: 35 sec, Warm start: 33 sec, Hot start: 1 sec |
| Accuracy | Position: 5-25 m CEP, Velocity: 0.1 m/sec |
| Display | 2.2 inch TFT touchscreen |
| Resolution | 240 x 320 pixels |
| Battery | 1300 mAh Li-ion rechargeable |
| Waterproof | IPX7 |
| Memory | 128 MB built-in |
| Expandable Memory | MicroSD card (up to 8GB) |
| Dimensions | 110 x 57 x 23 mm |
| Weight | 121 g |
General description of the MT100 GPS vehicle tracking product, highlighting its features and suitability.
Key applications including real-time tracking, security, and fleet management for various vehicles.
Lists various functions of the MT100 tracker, including alarms, tracking modes, and I/O capabilities.
Details technical specifications like dimension, weight, power, temperature, GPRS, and I/O.
Identifies the main unit and optional accessories for the MT100 device.
Instructions on how to install a SIM card into the MT100 device.
Guide on charging the device and understanding LED status indicators for GPS and GSM.
Details I/O cable pinout and power/ground connection to vehicle battery.
Explains digital input triggering and output usage for functions like SOS and immobilization.
How to get the current location of the MT100 via SMS or phone call.
Commands to receive physical address names and Google Maps URLs for location.
Commands for engine cut-off, over speed alarm, and harsh acceleration/braking alerts.
Commands for oil leaking/refuel alarms and impact detection.
Commands to set the tracker ID and APN settings for GPRS connection.
Commands to set server IP/Port and enable GPRS function (TCP/UDP).
Configures the time interval for sending data packets via GPRS.
Instructions for opening and connecting to the GPS Tracker Parameter Editor.
Explains the parameter settings available in the GPS Tracker Parameter Editor.
Commands for power saving, wiretapping, time zone, SOS alerts, and system initialization/reset.
Commands for tracking by angle/distance, device information, and address name reporting.
Commands for setting geofence alarms and configuring extended settings.
SMS commands for enabling, disabling, and managing RFID functions.
How to configure authorized RFID tags using specific SMS commands.
SMS commands to arm and disarm the system, affecting RFID function.
Steps to find and configure RFID settings using the Parameter Editor.
Enables/disables cutting off oil-way when illegally igniting under ARM status.
Lists commands for RFID configuration, arming, disarming, and functional interactions.
Explains how to use RFID features within the GPS Tracking Platform.
Steps for managing driver information and adding tag IDs in the platform.
To Next Page