Topshine MT100 - Geofence and Extended Settings

TOPSHINE TRACKING TECHNOLOGY USER MANUAL OF MT100
- 24 -
speeds higher
than the preset
value, it will
send one over
speed alarm
SMS to the SOS
preset
number.
Set Geo-fence
alarm
(foursquare)
When the MT100
moves out
of preset scope, it
will send
one Geo-fence
SMS to the
SOS preset
number.
W******,006,XX
XX (set distance from current central point
place )
=00, disable
=01, 30m
=02, 50m
=03, 100m
=04, 200m
=05, 300m
=06, 500m
=07, 1000m
=08, 2000m
Extend Settings W******,008,ABC
DEFGHIJ###
A=0, disable position report function
when a call is made to MT100
A=1, enable position report function to
get position SMS by Calling MT100
I=0, disable power failure alert
I=1, enable power failure alert
The functions of
BCDEFGHJ are
remained for furthur use.
### is the ending character.
Set Geo-fence
alarm
017 command is
for alarm when
tracker moves out
the preset scope;
117 command is
for alarm when
tracker moves in.
When the tracker
moves in or out, it
will send an SMS
alarm to the
authorized phone
number for SOS.
W******,017,data
W******,117,data
data is the coordinates which include:
Lower-left X, Lower-left Y,Upper-right
X,Upper-right Y
Forexample,
11404.0000,E,2232.0010,N,11505.1234,E,2333.
5678,N
Note:1. Lower-left X,Y (longitude and latitude)
should be smaller than Upper-right X,Y;
2. All longitudes and latitudes should be in ASCII
format as follows:-
Longitude: DDDMM.MMMM,E/W. 4 places of
decimal. ‘0’ is needed to be stuffed if no value
available.
Latitude: DDMM.MMMM,N/S. 4 places of
decimal. ‘0’ is needed to be stuffed if no value
available;