TOPSHINE TRACKING TECHNOLOGY USER MANUAL OF MT100
- 17 -
Appendix 1 Configure by computer
This part shows the basics of how to use the TOPSHINE Parameter Editor. Note: Don’t
connect MT100 to external battery when configuring.
How to Edit the Parameters of MT100
Step 1 Buy one specific USB cable for configuration from Our Company
Step 2 Install USB driver program for the configuration USB cable
1. Run “CP210x_Prolific_DriverInstaller” to install the driver for the USB data cable.
Note: CP210x_Prolific_DriverInstaller is in the folder ‘USB-232 Driver’ in the CD.
Connect the USB Data Cable between MT100 and PC.
2. Connect the configuration cable with PC, open device management of your computer.
You can find “Prolific USB-to-Serial Comm. Port ” , as following picture shows.
The USB port is virtual comm. Port (com3) in this example,
To Next Page
Loading...