TOPSHINE TRACKING TECHNOLOGY USER MANUAL OF MT100
- 22 -
This function is achievable
when the speed is below
10km/h and GPS is
available.
Out4, Out5 respectively.
If A or B or C or D or E,
=0, to disable the output
=1, to enable the output
=2, to remain previous status
Set power saving mode
when MT100 is still
(In power saving mode,
GPS stops working. GSM
enters standby mode and
stop sending out message
until it is activated by an
SMS or an incoming call)
W******,026,XX
XX=00, to disable this function
XX=01~99, to set this function. It
is in
unit of minute.
Example:
If XX=10, MT100 will enter
power
saving mode in 10 minutes after
it is
immobile.
Set phone number for
wiretapping
W******,030,T
T is the telephone number for
wiretapping and max. 16 digits
Set time zone difference W******,032,T
T=0, to disable this function
T=[1, 65535] to set time
difference in
minutes to GMT.
Default value is GMT
+, not necessary for those ahead
of
GMT. For example, either +120
or 120
is acceptable.
-, required for those behind GMT.
For
example, -120.
Set character for SOS
alert message
W******,033,P,Char
Char P is the button number.
P=1, 2, or 3.
Char is the character in SOS
message
and max 32 characters
Set tracking by driving
angle change function
W******,036,Degree
Measured by Degree(s),
Degree=0,disable this function；
X=1-359 ， means set angle
degree interval in this function.
Set tracking by distance
function
W******,045,X
Measured by Meter(s),
X=0, disable this function ；
X=1—65535 ， means the
distance interval in this function.
To Next Page
Loading...