EasyManua.ls Logo

Torc HYFLOW 230-2 - Replacing the Low-Pressure Cut off Valve

Default Icon
93 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Checks and repairs on hydraulic components
74
Check whether any oil is emitted from the tank pipe (F) at a pressure of less
than 50 bar.
If oil is emitted from the tank pipe, the low-pressure cut off valve is defective.
If the low-pressure cut off valve is defective, replace it, see from page 74.
Replacing the low-pressure cut off valve
WARNING
Slipping hazard from leaked oil.
Bruising and bone fractures possible.
Clean up any leaked oil with a cloth or suitable binding
agents.
Wear safety shoes with non-slip soles.
CAUTION
Health hazard from contact with hydraulic oil.
Wear nitrile gloves and chemical-resistant protective
goggles during work that may include contact with
hydraulic oil.

Table of Contents