8
After extended use of the RAPTOR Series Torque Wrench, the air pressure setting should be
re-checked and may require a minor adjustment. This is usually caused by variations in your air
supply unit providing airow to the F/R/L Unit or due to weather conditions.
.
In the case of degrading performance or other apparent damage, immediately send your
RAPTOR Series Torque Wrench to TorcUP, Inc or contact your Local Representative or
Distributor. The unit must be properly packaged for shipping.
OPERATING PROCEDURES
Unauthorized manipulation of air motor, valves, & TorcUP F/R/L Unit or tampering with
either will result in loss of warranty! Also, for the life of your TorcUP RAPTOR Series
Torque Wrench, the air supply should be clean and free of particles, water and other
remnants. Pollution of the hose couplings or aggressive substances reaching the air
motor via the supply hose may cause damage to the air motor vanes. Use approved
F/R/L Units to obtain oil-enriched and ltered supply. Non-compliance with the specied
operating air pressure will result in higher wear of the motor. Degradation in performance
is likely to result. Also, for extreme cold weather, use approved cold weather pneumatic
lubrication to prevent freeze ups.
Beware of low-pressure air components. Do not fold or bend the supply hose excessively and
check the hose for damage before use. A damaged hose must not be used, as there is a risk of
a hose burst. This may lead to a wildly lashing hose with a risk of personal injury. Also, check the
air tting and connections for tightness or damage.
OPERATING PROCEDURES
NOTICE
IMPORTANT
WARNING
To Next Page
Loading...
