3
USING THE TOOL
• Keep hands, loose clothing and long hair away from the reaction arm and working area during
operation.
• This tool will exert a strong reaction force. Use proper mechanical support and correct
reaction arm positioning to control these forces. Do not position the reaction arm so that it
tilts the tool off the axis of the bolt, and never use the swivel inlets as a reaction stop.
• Avoid sharp bends and kinks that will cause severe back-up pressure in hoses and lead to
premature hose failure.
• Use only accessories recommended by TorcUP.
• Use only impact sockets and accessories. Do not use hand (chrome) sockets or accessories.
• Use only sockets and accessories that correctly t the bolt or nut and function without tilting
the tool off the axis of the bolt.
• This tool is not insulated against electric shock.
• This equipment must not be operated or serviced unless the operator reads the operating
instructions and fully understands the purpose, consequences and procedures of each step.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY
Do NOT Exceed Maximum Pressure. See Torque Chart with Tool. Damage May Occur.
Always wear ear
protection
when operating
this tool.
Do not carry
the tool
by the hose.
Keep body stance
balanced and rm.
Do not overreach
when operating
this tool.
The Reaction Arm must be
positioned against a positive stop.
Do not use the arm as a dead
handle. Take precautions to
make certain the operator’s hand
cannot be pinched between
the arm and a solid object.
Do not use damaged,
frayed or deteriorated
pneumatic hoses
and ttings.
Always wear eye
protection
when operating or
performing
maintenance
on this tool.
WARNING
Depending on the working environment, your local health and safety regulations may require
you wear protective gear (i.e. safety shoes, hard hat, gloves, coveralls, etc.). In case external
forces are exerted on the equipment, non-compliance with these regulations may result in
injury. EAR PROTECTION MUST BE WORN WHEN OPERATING THIS TOOL.
To Next Page
Loading...
