Torishima Pump CAL - Sliding Clearance; When the pump is left unused for a long period

CAL Optional Design
- 10-
3.5. Sliding Clearance
Regarding the clearance between the case wearing ring and the
impeller sliding surface, the design value for the impeller whose
material is FC is φ0.4 mm, and the tolerance value is φ1.0 mm. The
design value for the impeller whose material is SCS is φ0.6 mm,
and the tolerance value is φ1.2 mm.
If the tolerance value is exceeded, replace the case wearing ring.
3.6. When the pump is left unused for a long
period
When the pump is left unused for a long period, execute break-in
operation for approx. 10 minutes once or twice a month. If break-in
operation cannot be performed, turn the shaft (2100) manually.