Instructions for Use TORMAX 2201 T-1165 e 5
Hazards can arise:
– in the region of the secondary closing edges
– door guides in the floor
– in the split in the cladding for suspending the door
– if objects, for example sales stands, are erected in direct proximity to the operating range of the door
leaves.
– due to deliberate damage by vandals, defective sensors or sensors which are no longer properly ad-
justed, sharp edges, incorrectly supported and defective casing or missing covers.
2.5 Checks
The regular checks and examinations set out in Chapter 6 must be carried out as instructed by the manu-
facturer. The manufacturer recommends that a maintenance contract be concluded in order to operate the
system safely and to maintain its value for as long as possible.
2.6 Decommissioning the System in the Event of a Fault
If there is a fault the automatic door may only be taken out of service by a skilled person, the operator or
a person who is instructed to do so by the operator. This must be done on all occasions on which the
safety of persons could be compromised.
• Disconnect the system from the power supply.
• Select operating mode Manual Operation, if the system continues to operate using the internal emer-
gency power supply (see section 4.2 for switching to manual operation).
• Open the door manually and leave open if it is installed in an escape route.
See section 7 for rectification of faults.
2.7 Disposal
This system must be properly dismantled at the end of its working life. Its disposal must comply with na-
tional regulations. We recommend that you contact a skilled person disposal company.
– Aggressive acids.
– Risk of injury if you dismantle the battery module.
– Dispose of batteries properly.
– Airborne parts.
– Risk of injury when dismantling the rubber cord suspension.
– Take care when releasing the tension on the rubber cord.
– Broken glass.
– Risk of injury when dismantling the door leaves.
– Take care when transporting the door leaves.
To Next Page
Loading...
Need help?
General
