13
DETERGENT SOLUTION TANK
Grab the hose cap (1) located on the left side of
the machine, pull out the hose and after
opening the cap, connect the hose to the water
valve. Fill the solution tank with clean water
at a temperature not over 122°F (50°C). Add
detergent solution with the concentration
provided by the manufacturer. To avoid the
excessive production of foam that could cause
damages to the suction motor, use a minimum
percentage detergent solution. On the rear
part of the machine is located the water level
hose, which allows users to see the amount of
detergent solution inside the tanks, both when
loading it and when working.
Always use a foam-controlled detergent. To
safely avoid the production of foam, before
starting to work, add also a small amount of
anti-foam solution in the recovery tank.
Never use pure acids.
A safety device prevents the machine’s
movement if the operator is not properly placed
on the footboard.
To turn on the machine:
1. Step on the footboard.
2. Turn the key (1) clockwise to turn on the
machine.
3. Check the battery level on the display.
The machine will go automatically in manual
mode (MAN).
4. Select the driving direction using the lever
(2).
WORK
5. Lower the squeegee using the lever (5).
MANUAL MODE WORK
1. Check that the machine is set in manual
mode, if not press button (1) and the display
will show the corresponding symbol.
2. Press the suction motor button (2); the
suction motor symbol changes depending if the
motor is turned on or off, the motor will then
start to work.
3. Press the solenoid valve button (3); the
solenoid valve symbol changes depending if
the valve is closed or open.
4. Lower the brush base on the floor pressing
button (4); the display will show first the lifting
down symbol and then the brush on symbol
To Next Page
Loading...
Need help?
General