20
RECOMMENDED BRUSH
Brush must be chosen depending on type of floor and dirt to be removed. The employed material
and the bristle diameter are the elements that distinguish different types of brush.
PROGRAMMED MAINTENANCE
PERIODIC ORDINARY MAINTENANCE CHART
INTERVENTION DAILY PERIODIC
RECOVERY TANK CLEANING •
SUCTION FILTER CLEANING •
SOLUTION TANK FILTER CLEANING •
BRUSHES CLEANING •
BRUSHES DISASSEMBLY AND CLEANING •
SQUEEGEE CLEANING •
FRONT SQUEEGEE RUBBER CHECK •
REAR SQUEEGEE RUBBER CHECK •
SPLASH GUARD RUBBER CHECK •
CHECK SQUEEGEE ADJUSTMENT •
SQUEEGEE HOSE CLEANING •
SOLUTION TANK CLEANING •
CHECK BATTERIES ELECTROLYTE •
MATERIAL CHARACTERISTICS
PPL (Polypropylene) Good wear resistance. Maintains a characteristic with hot water up to
140°F (60°C). It is not hygroscopic.
NYLON Excellent wear resistance, even with hot water over 60°C. It is hygroscopic. It looses its
physical characteristics over time.
TYNEX Nylon bristles with grains of abrasive material. Use with caution in order not to mark the
floor or ruin the polishing.
BRISTLES THICKNESS Thicker bristles are more rigid and must be used on smooth floor or
floor with small joints. On irregular floors with deep joints or relieves, it is recommended to use
softer bristles which penetrate more easily and deeper. Please be aware that when brush bris-
tles are worn out and therefore too small, they become rigid and unable to penetrate and clean
deeper. This may also happen with thicker bristles creating brush vibration.
PAD HOLDER It is equipped with anchor points that permit the locking of the abrasive pad. The
pad is recommended to clean smooth floors.
CODE QTY DESCRIPTION USE
48902010 1 Brush PPL 0.3 Irregular floors with large joints.
48902020 1 Brush PPL 0.7 Smooth floors with small joints and persistent dirt.
48902030 1 Brush PPL 0.9 Smooth floors with small joints and persistent dirt.
48902040 1 Brush TYNEX Floors of resistant material and particularly dirty.
48902050 1 Brush PPL 0.6 Normal floors.
48902060 1 Brush 5-mix For all types of floors.
48802010 1 Pad holder + center lock
green
For pads of 20”, for smooth surfaces cleaning.
To Next Page
Loading...
Need help?
General