8
NAVIGATION CONTROLS
GENERAL SETTINGS
To enter the settings menu, use the dashboard
buttons and proceed as follows:
1. Keep buttons (1) and (5) pressed
simultaneously
2. Turn the key switch on
3. When “INSERT PASSWORD:0” is shown on
the display, press button (2) to confirm.
Once entered the GENERAL SETTINGS it will
be possible to change the following settings
by simply scrolling through the menu using
buttons (1) and (3).
SELECT THE DISPLAY LANGUAGE
English is the default language, it is possible to
switch to Italian.
To select the language scroll with the button
(1) and (3) until is shown “Language”. Press
buttons (4) and (5) to select the language. Press
button (2) to confirm.
CHANGE THE BATTERY SETTING
Once entered the general settings it is possible
to set the machine depending on the batteries
installed (AGM / GEL / LEAD-ACID / XFC).
To select the setting scroll using buttons (1)
and (3) until is shown “Battery”. Press buttons
(4) and (5) to select the battery type. Press
button (2) to confirm.
A wrong setting could damage the batteries
irreparably.
ALWAYS verify that the correct parameter is
set.
The battery setting can bee seen when
turning on the machine (see “SETTING THE
BATTERIES or READING THE DISPLAY”).
DISPLAY CONTRAST
Once entered the general settings it is possible
to set the display tune
Scroll with the button (1) and (3) until is shown
“Display tune”. Press buttons (4) and (5) to
select the tune. Press button (2) to confirm.
DISPLAY BRIGHTNESS
Once entered the general settings it is possible
to set the display brightness.
Scroll with the button (1) and (3) until is shown
“Display brightness”.
Press buttons (4) and (5) to select the
brightness. Press button (2) to confirm.
To Next Page
Loading...
Need help?
General