Overview of the InfoCenter Display (continued)
7. After you select YES, the interval screen clears and reverts back to the service hours
selections.
Setting the Blade Count
1. In Machine Settings, scroll down to Blade Count.
2. Press the right navigation button to change the blade count between 8 or 11 blade reels.
Setting the Height of Cut (HOC)
1. In Machine Settings, scroll down to Height of Cut.
2. Use the left and right navigation buttons to select the HOC setting that matches the
bench setting of the cutting units. If the exact setting is not displayed, select the nearest
HOC setting from the list displayed.
Setting the Front and Rear Reel Speeds
Although the front and rear reel speeds are calculated by inputting the number of blades,
mow speed and HOC into the InfoCenter display, the setting can be manually changed to
accommodate for different mowing conditions.
1. To change the Reel Speed Settings, scroll down to the F R
EEL RPM, R REEL RPM, or
both.
2. Press the right button to change the reel speed value. As you change the speed setting,
the display continues to show the calculated reel speed based on blade count, mow
speed and HOC, which was previously entered, but the new value is also displayed.
Setting the Maximum Allowed Mow Speed
The selected setting is displayed as an X on the traction-speed bar graph along with the
cruise control and pedal stop settings. An X in a bar denotes that the maximum speed is
limited by the supervisor.
Note: This setting is retained in memory and applied to the traction speed until you change
it.
1. In Machine Settings, scroll down to Mow Speed.
2. Use the left and right navigation buttons to increase and decrease the maximum mow
speed in 0.8 km/h (0.5 mph) increments between 1.6 and 12.9 km/h (1.0 and 8.0 mph).
Setting the Maximum Allowed Transport Speed
The selected setting is displayed as an X on the traction-speed bar graph along with the
cruise control and pedal stop settings. An X in a bar denotes that the maximum speed is
limited by the supervisor.
Note: This setting is retained in memory and applied to the traction speed until you change
it.
Operation: Before Operation Page 5–12 3464-482 A
To Next Page
Loading...
