Overview of the InfoCenter Display (continued)
1. In Machine Settings, scroll down to Transport Speed.
2. Use the left and right navigation buttons to increase and decrease the maximum
transport speed in 0.8 km/h (0.5 mph) increments between 8.0 and 16.0 km/h (5.0 and
10.0 mph).
Turning the Smart Power ON/OFF
1. In Settings, scroll down to Smart Power.
2. Press the right navigation button to switch between O
N and OFF.
Setting the Acceleration Mode
1. In Machine Settings, scroll down to Acceleration.
2. Press the right navigation button to switch between L
OW, MEDIUM, and HIGH.
Accessing the Technician Menu
Note: For operating convenience, you may decide to perform a parked regeneration before
the soot load reaches 100%, provided the engine has run more than 50 hours since the last
successful reset, parked, or recovery regeneration.
Use the Technician menu to view the current state of engine regeneration control and the
current soot level.
1. In Settings, scroll down to DPF Regeneration and press the select button.
G484116s
2. In DPF Regeneration, scroll down to
Technician and press the select button.
3464-482A Page 5–13 Operation: Before Operation
To Next Page
Loading...
