Toro 04384 - Page 109

Greensmaster 3250--D Hydraulic SystemPage 4 -- 7 7
5. If hydraulic fittings are to be removed from reel mo-
tor, mark fitting orientation to allow correct assembly.
Remove hydraulic fittings and O--rings from motor. Dis-
card removed O--rings.
6. Inspect threads and sealing surfaces of fittings and
motor ports. Replace components if damage is found.
Installation (Figs. 50 and 51)
1. If fittings were removed from reel motor, lubricate
and place new O--rings onto fittings. Install fittings into
reel motor openings making sure that fitting orientation
isasnotedduringremoval.Tightenfittings(seeHydrau-
lic Fitting Installation in the General Information section
of this chapter).
2. Coat spline shaft of the reel motor with No. 2 multi-
purpose lithium base grease.
3. Rotate the motor clockwise so the motor flanges
clearthe cap screwsinthecuttingunit side plates.Align
reel motor shaft splines with cutting reel insert splines.
Slide motor shaft into reel insert.
4. Rotate the motor counterclockwise until the motor
flanges a re encircling the cap screws. Tighten two (2)
cap screws to secure reel motor to cutting unit.
5. Remove caps and p lugs from disconnected hydrau-
lic hoses and motor fittings.
6. Using labelsplacedduringreel motorremoval,lubri-
cate new O--rings and connect hydraulic hoses to reel
motor. Tighten hose connections (see Hydraulic Hose
andTube Installation in theGeneralInformationsection
of this chapter).
7. Check oil level in hydraulicreservoirandaddcorrect
oil if necessary.
8. Follow Hydraulic System Start--u p procedures (see
Hydraulic System Start--up in this section).
1. Bulkhead lock nut
2. Bulkhead lock nut
3. Washer head screw
4. Hydraulic hose
5. Center reel motor
6. Bulkhead bracket
7. Hydraulic tube
8. Hydraulic hose
9. Washer
10. Spacer
11. Grommet
12. Hydraulic straight fitting
13. 90
o
hydraulic fitting
14. Hose bracket
15. O--ring
16. Hydraulic hose
17. O--ring
18. O--ring
19. O--ring
20. Tube clamp
21. Cap screw
22. Lock nut
23. Hydraulic T--fitting
24. Hose retainer
25. Lock nut
26. Hose retainer
27. Cable tie
Figure 51
FRONT
RIGHT
9
10
6
9
10
20
9
8
4
13
5
12
4
1
24
22
3
26
15
11
3
25
14
27
9
23
11
2
1
16
21
7
3
13
19
17
18
CENTER REEL MOTOR
Hydraulic
System