Toro 04384 - Grooming Reel

Greensmaster 3250--DGroomer Page 8 -- 8
Grooming Reel
Figure 4
1. Lock nut (4 used)
2. Drive cover
3. Groomer drive belt
4. Drive pulley
5. Shoulder bolt (2 used)
6. Spring
7. Drive plate assembly
8. Groomer shim
9. RH groomer arm assembly
10. Cap screw (2 used)
11. Bushing (2 used)
12. Spring washer (2 used)
13. Lock nut (2 used)
14. Support plate
15. LH groomer arm assembly
16. Special washer (2 used)
17. Rear roller height shim
18. Socket head screw (4 used)
19. Driven pulley
20. HOC screw (2 used)
21. HOC nut (2 used)
22. Plow bolt (2 used)
23. Grooming reel assembly
24. Front roller assembly
25. RH cutting unit sideplate
26. LH cutting unit sideplate
27. O--ring
FRONT
RIGHT
Antiseize
Lubricant
100 ft--lb
(135 N--m)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
1
20
21
22
23
24
11
12
13
25
26
27
17 to 21 ft--lb
(24to28N--m)
Removethe grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft or to replace the grooming shaft.
NOTE: The drive assembly for the grooming reel is lo-
catedontheoppositesideofthecuttingunitfromthehy-
draulic cutting reel motor. Figure 4 shows the grooming
reel drive on the right side of the cutting unit.
Removal (Fig. 4)
1. Park machine on a clean and level s urface, lower
cutting units completely to the ground, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Remove the cutting unitfromthemachine and place
cutting unit on a flat work area.