Greensmaster 3250--D
DPA Cutting Units
Page 7 -- 11
Leveling Rear Roller
The precision machined components of the cutting unit
frame keep the rear roller and cutting reel in alignment
(parallel). If the side plates are disassembled or as the
cuttingreelwears, alimitedamountof sideplateadjust-
ment is possible to make sure that the cutting unit is
properly aligned.
1. Place the assembled cutting unit on a surface plate.
2. Make sure that bedknife is properly adjusted to cut-
ting reel.
3. Using the surfaceplate,check if rear rolleris level to
cutting reel by using a 0.005” (0.13 mm) shim at each
end of rear roller. If the s him will pass under the roller at
oneendbutnotthe other,aframeadjustmentshouldbe
made.
4. Loosen, but do not remove, the two (2) shoulder
boltsthatsecurethesideplatetotheframeoppositethe
side that is not level (Fig. 10).
5. Adjust the position of the side plate to parallel the
rear roller and cutting reel. Then, tighten the shoulder
bolts to a torque from 210 to 240 in--lb (24 to 27 N--m).
6. Aftertighteningthesideplate,rechecktherearroller.
If necessary, loosen and adjust s econd side plate.
7. Afterlevelingrearroller,completecuttingunitset--up
and adjustment sequence.
1. Side plate
2. Shoulder bolt
3. Rear roller
Figure 10
2
3
1
2
DPA Cutting
Units
To Next Page
Loading...
