Toro 04384 - Reel Motor Service

Greensmaster 3250--DHydraulic System Page 4 -- 78
Reel Motor Service
1. Rear cover
2. Drive gear
3. Seal
4. Tab washer
5. Pressure seal
6. Back--up ring
7. O--ring
8. Body
9. Idler gear
10. Cap screw (4 used)
11. Front flange
12. Washer (if equipped)
Figure 52
7
4
3
1
2
5
6
9
10
11
(24to32N--m)
215 to 280 in--lb
8
5
6
7
12
Disassembly
1. Plug motor ports and clean the outside of the motor
thoroughly. After cleaning, remove plugs and drain any
oil out of the motor.
2. Useamarkerorscribetomakeadiagonal mark
across the front flange, body and rear cover for reas-
sembly purposes (Fig. 53).
IMPORTANT: Avoid using excessive clamping
pressure on the motor flange to prevent distorting
the casting.
3. Clamp mounting flange of motor in a vise with the
shaft end down.
4. Loosen cap screws on the rear cover.
5. Take motor from the vise and remove cap screws.
6. Removefrontflangefromthebody,thenremoverear
cover. Locate and remove dowel pins from body.
Figure 53
DIAGONAL MARK