Toro 04616 - Table of Contents; Introduction

Introduction
Readthisinformationcarefullytolearnhowtooperate
andmaintainyourproductproperlyandtoavoidinjury
andproductdamage.Youareresponsibleforoperating
theproductproperlyandsafely.
YoumaycontactTorodirectlyatwww.Toro.comfor
productandaccessoryinformation,helpndinga
dealer,ortoregisteryourproduct.
Wheneveryouneedservice,genuineToroparts,or
additionalinformation,contactanAuthorizedService
DealerorToroCustomerServiceandhavethemodel
andserialnumbersofyourproductready.
Figure1
identiesthelocationofthemodelandserialnumbers
ontheproduct.Writethenumbersinthespace
provided.
Figure1
1.Locationofthemodelandserialnumbers
ModelNo.
SerialNo.
Thismanualidentiespotentialhazardsandhas
safetymessagesidentiedbythesafetyalertsymbol
(Figure2),whichsignalsahazardthatmaycauseserious
injuryordeathifyoudonotfollowtherecommended
precautions.
Figure2
1.Safetyalertsymbol
Thismanualuses2otherwordstohighlightinformation.
Importantcallsattentiontospecialmechanical
informationandNoteemphasizesgeneralinformation
worthyofspecialattention.
Contents
Introduction.................................................................2
Safety...........................................................................3
SafetyandInstructionalDecals.............................3
Setup............................................................................4
1InstallingtheFrontRoller..................................4
2InstallingtheHoopLink,OffsetLinkor
ChainLink.......................................................4
3UsingtheCuttingUnitProp...............................5
4InstallingtheCounterWeights...........................5
5AdjustingtheBedknifetotheReel......................6
6AdjustingtheRearRoller...................................7
7AdjustingtheHeightofCut...............................8
8AdjustingtheCut-OffBar..................................9
ProductOverview......................................................10
Specications.....................................................10
Attachments/Accessories...................................10
Operation...................................................................11
CuttingUnitCharacteristics................................11
DailyAdjustmentsofCuttingUnit......................11
Maintenance...............................................................12
ServicingtheBedbar...........................................12
BacklappingtheReel..........................................13
©2011—TheToro®Company
8111LyndaleAvenueSouth
Bloomington,MN55420
2
Contactusatwww.Toro.com.
PrintedintheUSA.
AllRightsReserved