Toro 04616 - Adjusting the Bedknife to the Reel

Figure7
1.Counterweight
2.Ontherightendofthecuttingunit,removethe
plasticplugfromthebearinghousing(Figure8).
3.Removethe(2)Allenheadscrewssecuringthe
motormounttotherightendofthecuttingunit.
Removethemotormount(Figure8).
Figure8
1.Motormount
3.Allenheadscrew(2)
2.Plasticplug
4.Removethesnapringsecuringthedrivecouplerin
thereeltube(Figure9).Removethedrivecoupler.
Figure9
1.Snapring
2.Drivecoupler
5.Applygreasetotheinsidediameterofthedrive
coupler.Installthedrivecouplertotheleftendof
thecuttingunitreeltubewithasnapring(Figure9).
6.Installthemotormounttotheleftendofthecutting
unitwiththe(2)Allenheadscrewspreviously
removedin
Figure8.Torquescrewsto12-15ft-lbs.
(16-20N-m).
7.Installthecounterweighttotherightendofthe
cuttingunitwiththescrewspreviouslyremoved.
5
AdjustingtheBedknifetothe
Reel
NoPartsRequired
Procedure
Thebedknifetoreeladjustmentisaccomplishedby
looseningortighteningthebedbaradjustingscrews,
locatedontopofmower.
1.Positionthemachineonaat,levelworksurface.
Makesurereelcontactisremovedbyturning
thebedbaradjustingscrewscounterclockwise
(Figure10).
6