Why does the machine-status light flash 8 times on my Toro Utility Vehicle?
The machine-status light flashes 8 times because the controller or motor is overheated or too cold. Determine if the motor or controller is very hot or very cold, then allow the machine to return to safe temperatures before resuming normal operation.
What to do if the machine-status light on my Toro 07433LT Utility Vehicle flashes 13 times?
If the machine-status light flashed 13 times, an internal-software fault occurred. Contact your Authorized Service Dealer.
What to do if the machine-status light flashed 6 times on my Toro 07433LT?
If the machine-status light flashes 6 times, it could be because the throttle is pressed while starting the machine or a wire is not making a connection. Release the pedal, turn the key switch to the OFF position, wait a few seconds, turn the key switch to the ON position, and check for normal operation. Also, test the wiring between the controller and contactor, switches, and the status-indicator light.
What to do if my Toro 07433LT Utility Vehicle displays error code E-0-2-3?
If your Toro Utility Vehicle displays error code E-0-2-3, it indicates a high AC voltage error (greater than 270VAC). Connect the charger to an AC source that provides stable AC between 85 - 270 VAC / 45-65 Hz.
What to do if the machine-status light is not illuminated on my Toro Utility Vehicle?
If the machine-status light is not illuminated, there is either no power to the controller or the controller has failed. Contact your Authorized Service Dealer.
What to do if my Toro 07433LT Utility Vehicle shows error code P0E8E or P156C?
If your Toro Utility Vehicle displays error code P0E8E or P156C, it means the batteries have a low charge, are fully discharged, or the internal capacitor has a pre-charge of less than 5V. Stop operation, drive slowly to the nearest charging station, and fully charge the batteries.
What to do if my Toro 07433LT Utility Vehicle displays error code E-0-0-1 or E-0-4-7?
If your Toro Utility Vehicle displays error code E-0-0-1, or E-0-4-7, it indicates a battery high voltage issue. Ensure that the battery voltage is correct and the cable connections are secure; ensure that the battery is in good condition.
What does machine-status light flashing 11 times mean on my Toro Utility Vehicle?
If the machine-status light flashes 11 times, it indicates a motor-encoder fault or exceeding the maximum motor speed. Check the motor-encoder (speed sensor) wiring. If the speed was exceeded, turn the key switch to the OFF position, wait a few seconds, turn the key switch to the ON position, and check for normal operation.
Why does the machine-status light flash 6 times on my Toro 07433LT Utility Vehicle?
If the machine-status light on your Toro Utility Vehicle flashes 6 times, it means that the throttle is pressed while starting the machine or there is a wire that is not making a connection. Release the pedal, turn the key switch to the OFF position, wait a few seconds, turn the key switch to the ON position, and check for normal operation. Also, test the wiring between the controller and contactor, switches, and the status-indicator light.
What to do if the machine-status light flashed 3 times on my Toro 07433LT?
If the machine-status light on your Toro Utility Vehicle flashes 3 times, it indicates that the motor current exceeded the controller-rated maximum or there is an internal-power component fault. Turn the key switch to the OFF position, wait a few seconds, and then turn it back to the ON position. Check all batteries and high-current controller connections. If the condition continues, contact your Authorized Service Dealer.
General| Brand | Toro |
|---|---|
| Model | 07433LT |
| Category | Utility Vehicle |
| Language | English |
To Next Page
