Toro 522 Power Throw - Setup and Assembly; Loose Parts Verification and Handle Installation

Setup
LooseParts
Usethechartbelowtoverifythatallpartshavebeenshipped.
ProcedureDescription
Qty.
Use
Handle1
Bolts4
Bellevillewashers4
1.
Flangenut1
Installthehandle.
Speedselectorrod
1
Cotterpin
1
2.
Flatwasher1
Installthespeedselectorrod.
3.
Flangelocknut1Installthetractionrod.
Clevispin
1
4.
Cotterpin
1
Installtheauger/impellerdrivecontrol
linkage.
Chutecontrolrodassembly(rodand
bracket,wormgear,andbracket)
1
Carriagebolt
1
Bellevillewasher1
Hexheadbolt1
5.
Locknut2
Installthechutecontrolrod.
6.
Nopartsrequired
–
Filltheenginewithoil.
7.
Nopartsrequired
–
Checkthetirepressure.
8.
Nopartsrequired
–
Checktheskidsandscraper.
1.InstallingtheHandle
1Handle
4Bolts
4Bellevillewashers
1Flangenut
Procedure
1.Removethetiestrapsthatsecurethecontrolrods
tothehandle.
2.Removetheaxlepinsfrombothwheelsandslidethe
wheelsoutwardontheaxleapproximately1inch(3
cm)(Figure3).
Figure3
1.Axlepin(2)
3.Handle
2.Capscrewandcurved
washer(4)
7