What to do if Toro Lawn Mower machine does not drive?
If your Toro Lawn Mower isn't driving, try these solutions: * Tighten the bypass valves. * Change the belt. * Replace the spring. * Add hydraulic oil to the reservoirs or let it cool down.
What to do if my Toro Lawn Mower starter does not crank?
If the starter does not crank, check the following: Ensure the blade-control switch (PTO) is disengaged. Set the parking brake. Make sure the motion-control levers are in the neutral-lock position. Ensure the operator is seated. If these aren't the issue, charge the battery and check the electrical connections for good contact. Also, replace the fuse if it's blown. For relay or switch issues, contact an Authorized Service Dealer.
What to do if my Toro Lawn Mower is vibrating abnormally?
If your Toro Lawn Mower is vibrating abnormally, here are some things to check: 1. The cutting blades may be bent or unbalanced, in which case you should install new cutting blades. 2. The blade mounting bolt may be loose, so tighten it. 3. The engine mounting bolts may be loose, so tighten them. 4. The engine pulley, idler pulley, or blade pulley may be loose, so tighten the appropriate pulley. For damaged engine pulleys, bent blade spindles, or loose/worn motor mounts, contact an Authorized Service Dealer.
Why is my Toro Lawn Mower engine overheating?
The engine may overheat if the engine load is excessive, so reduce the ground speed. Also, check if the oil level in the crankcase is low and add oil if needed. Another possible cause is plugged cooling fins and air passages above the engine, so remove any obstructions.
General| Model | 74143 |
|---|---|
| Drive Type | Self-Propelled |
| Power Source | Gasoline |
| Deck Material | Steel |
| Engine Type | 4-Cycle |
| Type | Walk-Behind Mower |
| Engine | Briggs & Stratton |
| Cutting Width | 22 inches |
| Oil Capacity | 20 oz |
To Next Page
