Toro 74534TE GrandStand - Drive System Maintenance

3
g017848
Figure56
1.Leftcableadjustment
3.Rightcableadjustment
2.Cablelock
7.Checkforpropertracking.
Note:Ifthemachinedoesnotstartafteradjustingthe
tracking,makesurethattheproximityswitchtarget
alignswiththeboltattachedtothemotion-control
lever;refertoAdjustingtheProximitySwitch(page42).
8.Repeatthecableadjustmentuntilthetrackingis
correct.
9.Checkthatthemachinedoesnotcreepfromneutral
withtheparkbrakesdisengaged.
Important:Donotrotatethelinkagetoofar,asthis
maycausethemachinetocreepinneutral.
AdjustingtheProximitySwitch
Usethisprocedureifthemachinedoesnotstartafter
adjustingthetracking.
1.Ensurethattheboltattachedtothemotion-control
leveralignswiththeproximity-switchtarget(Figure57).
2.Ifneeded,loosentheboltsandadjusttheproximity
switchuntilthetargetalignswiththeboltattachedto
themotion-controllever(Figure57).
3.Checkthedistanceofthebolttotheproximityswitch;
itneedstobebetween0.51to1.02mm(0.02to0.04
inches)asshowninFigure57.
4.Ifadjustmentisneeded,loosenthejamnutandadjust
thebolttothecorrectdistance.
5.Tightenthejamnutafteradjustingthebolt(Figure57).
6.Testthesafety-interlocksystembeforeoperation.
G015609
1 6
2 3 4
4
2
5
6
Figure57
1.Proximity-switchtarget4.Boltattachedtothe
motion-controllever
2.Proximityswitch
5.0.51to1.02mm(0.02to
0.04inches)
3.Boltsandnuts6.Jamnut
42