Toro 74534TE GrandStand - Page 58

MatchingtheRearoftheMowerDeck
1.Positiontheleftandrightbladesfront-to-rear.
2.MeasuretheleftbladeattheBlocation,fromalevel
surfacetothecuttingedgeofthebladetip,andrecord
thismeasurement(Figure85).
3.MeasuretherightbladeattheDlocation,fromalevel
surfacetothecuttingedgeofthebladetip,andrecord
thismeasurement(Figure85).
Note:ThemeasurementatpositionBneedstobe
within3mm(1/8inch)ofthemeasurementatposition
D.(Figure85).Ifitisnotcorrect,proceedtothe
followingsteps.
4.Loosenthejamnutsattheleftfrontswivel.
5.Usingtheleftjamnuts,adjustthelengthoftheleft
handthreadedroduntillocationBmatcheslocationD.
6.Tightenthejamnutsattheleftfrontswivel.
g020859
B
D
Figure85
1.Measureherefromblade
tohardsurface
2.MeasureatBandD
LevelingtheFrontoftheMowerDeck
1.Positiontheleftandrightbladesfront-to-rear.
2.Inspectthefrontchainsandensurethateachchain
hastension.
Note:Ifeitherchainisloose,adjustthethreadedrod
withtheloosechaintoachievetensiononthatchain.
3.MeasuretheleftbladeattheAlocation,fromalevel
surfacetothecuttingedgeofthebladetip,andrecord
thismeasurement(Figure86).
4.MeasuretherightbladeattheClocation,fromalevel
surfacetothecuttingedgeofthebladetip,andrecord
thismeasurement(Figure86).
Note:ThemeasurementbetweenlocationAandC
needstobewithin3mm(1/8inch).Ifitisnotcorrect,
proceedtothefollowingsteps.
5.Loosentheupperchainbolts(Figure82).
6.Loosenthejamnutsoneachyoke.
7.Adjusttheadjustmentboltsintheyokes,atlocationsA
andC,toachievethecorrectheight.
8.Tightenthejamnutsandupperchainbolts.
g020860
C
A
Figure86
1.Measureherefromblade
tohardsurface.
2.MeasureatAandC.
58