Toro 74939 - Page 56

1
3
2
G017027
Figure89
1.Deckliftpedal
3.Transportlock
2.Heightofcutpin
6.Inserttheheightadjustmentpinintothe7.6cm(3
inches)cuttingheightlocation.
7.Releasethetransportlockandallowthedecktolower
tothecuttingheight.
8.Raisethedischargechute.
9.Onbothsidesofthedeck,measurefromthelevel
surfacetothefronttipoftheblade(PostionA).
Note:Themeasurementshouldread7.6cm(3inches)
(Figure90).
Figure90
1.7.6cm(3inches)atAis
correct
3.Measureherefromthe
bladetiptohardsurface.
2.8.3cms(31/4inche)atB
iscorrect
4.MeasureatAandBon
bothsides.
10.FormowerdecksshowninFigure91,ne-tunethe
adjustmentnutonthefrontdeckliftassemblyby
turningit(Figure91).
Toincreasetheheight,turntheadjustmentnut
clockwise;todecrease,turnitcounterclockwise.
G012430
1
2
2 1
3 4
Figure91
1.Adjustmentnut3.Reardeckadjustment
2.Jamnut4.Frontdeckadjustment
11.FormowerdecksshowninFigure92,ne-tunethe
adjustmentnutonthefrontdeckliftassemblyby
turningit(Figure92).
Toincreasetheheight,turntheadjustmentnut
clockwise;todecrease,turnitcounterclockwise.
Figure92
1.Whizlocknut3.Jamnut
2.Adjusterscrew4.Yoke
56